We spend so much time in the kitchen that even the newly renovated interior starts to get bored very quickly. But doing repairs every two to three months is unrealistic. Refresh the same interior space can be by placing on the wall some colorful image. Wall panels for kitchen , made by own hands, will not only decorate the room, but will also give it originality and make it unique.
Decorative decoupage-panel for the kitchen
In order to make a unique attribute for decorating your kitchen you will need:
- sheet of fiberboard;
- rice paper:
- adhesive for decoupage ;
- PVA glue;
- eggshell;
- priming;
- brushes;
- sponges;
- acrylic paints for sketching;
- contours;
- file.
After preparing all the necessary attributes, you can start making the panel itself. First, it is necessary to apply a primer on the fiberboard from the smooth side.
The primer is applied with a thin layer using a sponge and dries very quickly. Then you can proceed to egg krakla. To begin with, a small area should be greased with glue.
On the glue you need to put a small piece of shell.
With the help of a toothpick, you need to press on the shell in the place where you want it to burst.
In order for the shells to lie neatly, they must be processed - after you break the egg should be removed from the inside of the shell to remove the film. It is better to do it immediately, because after the time the film is removed very badly.
The color of the shell does not matter, but do not use the pieces with the stamp printed on it - it can then show up on the panel.
After you break the shell into the necessary pieces, you should use the same toothpick to stretch them to the desired distance.
In the end, that's what should happen.
In order to keep the shell more reliably, it should be glued on top with a layer of glue.
After the adhesive dries completely, the surface is primed again.
The primer can be left to dry independently, and can be dried with a hair dryer.
Then proceed to apply the fragment. To do this, you can use rice paper, a napkin or a printout with the drawing you like. But it's more pleasant to work with rice paper.
Rice paper is placed on the file with the front side.
After it should be watered.
After the whole fragment is covered with water, you should turn the file and apply it with rice paper to the workpiece.
To ensure that everything turned out neatly, the paper should be straightened with a roller or just with your hands. When the surface is level, you can shoot the file.
After the paper dries completely, a glue is applied with a brush to decoupage. And it turns out this kind of beauty.
Thus, you see that it is not at all difficult to make a kitchen panel for your kitchen.