Very often in an apartment or house there is a need to establish an additional partition or partition, for example, partition a large room into two parts for two children or separate in the bedroom a space for a wardrobe, you can also divide the living room into a recreation area and reception of guests, etc. One of the simplest and quickest options is the installation of a partition of plasterboard with a door.
Of course, there may be a question - how to install a door in a drywall partition? To decide on the implementation of this issue, you should have at least some experience in similar work, as well as a step-by-step instruction that you must strictly follow and of course materials and tools.
Is strength calculation necessary?
The partition is not a load-bearing structure, and there is no need to make special calculations of strength. This can not be said of the case when it has a door - an additional load occurs on the partition, especially when opening and closing. If there is a doorway in the plasterboard wall - the frame is made with the establishment of a large number of transverse profiles and vertical racks.
MarkupFirstly, a line is laid on the floor, where there will be a partition, it must be perpendicular to the walls. On the ceiling draw with a plumb line, which then connects with the bottom on the walls. It is necessary to check the lines with a level.
The main points in fixing the profile and installing drywall
The profile is fixed along the drawn strips and fixed with screws. In the case where the door is located near the door, the lower profile should be reduced by the width of the door, and if it is in the middle - the profile is divided in half into two equal parts, which will be fastened from the door to the wall. To reduce sound insulation and noise insulation in places where the profile is fixed to the wall, a sealing tape is glued. The profile is fixed with an interval of 40-50 cm.
Strengthening the partition from the plasterboard in the place of the doorway is very important. To the profile, screwed on the floor and ceiling, you need to attach two vertical racks - this is the boundaries of the opening. The metal should not be very thin, usually its thickness is 0,4 - 0,6 mm, but not thinner. to them will be bolted the door box. When ceilings are above 2.5 m, they should be reinforced with reinforced profiles, in this case the material costs become larger, but this increases the margin of safety.
When the carcass assembly is completed, the plasterboard is fastened with screws, shpaklyuetsya, paint is applied, wallpaper is glued or any other finish is made.
If the room already has partition walls with a door, there are usually no problems - it is installed as standard on any wall. The main thing is that the box was perfectly rectangular and corresponded to all the dimensions of the door.
What is the reason for the popularity of the plasterboard partitions?
- their cost is not high, the materials are available, there are no problems with the acquisition;
- they are sufficiently reliable, if all rules are observed during the installation, even a doorway in the partition can withstand a wooden door;
- from gipsokartona it is possible to mount various designs of unusual and non-standard forms - from a partition to decorative shelves with illuminations;
- on top of these partitions can be covered with any kind of decorative design: paint, wallpaper wallpaper, make a structural filler and even put a tile;
- gypsum cardboard is considered an environmentally friendly material and it can be used in any room in an apartment or house, there are no harmful substances in its structure.
At present it is very actual to make re-planning of a premise - with the help gypsum cardboard partitions this question is easily solved, and you can embody all your design ideas and ideas.
| | | |
| | | |
| | | |
