How to sew a house with siding?

If you doubt how to sidewall the house, choose vinyl . It is relatively inexpensive, extremely simple to install, has excellent performance.

How to insulate the house before facing the siding?

First of all, it is worth considering that this is a multi-layer construction. The ventilated facade shows itself well for many years. The basis can be a supporting structure made of any material - blocks, bricks, wood, concrete.

1. First it is necessary to erect a crate, it is most convenient to choose a beam of 50x50 mm. When the frame is ready, start filling the sections with a heater. In this case, mineral wool will be used in 2 layers of 50 mm, total 100 mm of insulation. Over the first layer of insulation is better to install another crate.
2. The step of the bar should correspond to the width of the insulation liner. In order to avoid additional fastening of these plates, the step of the crate must be less by 10-20 mm. The width of the mineral wool is 600 mm, the selected pitch is 580-590 mm.
3. On mineral wool, trim with a knife or a special hacksaw with small teeth. The space between the crate is filled with a non-combustible heater. Move in stages.
4. The thickness of one row is 50 mm. Everything is "planted" on self-tapping screws.
5. For the maximum "set" before finishing the facade siding is to erect a second crate, going horizontally to the floor. Thus, cold bridges will not be formed.
6. The next layer is steam, waterproofing. The membrane is fixed with an overlap of 100 mm. For tightness, it is recommended to use a double-sided adhesive tape.

How to properly sew a house siding?

Work on the insulation of the facade is over. Sewing the house from the outside with siding can be as follows:

1. Strictly after 400 mm, install vertical metal guides. In fact, you need to make a third crate. Between the membrane and the siding there will be a gap of 30-50 mm, which promotes ventilation.
2. Further, the starting profile and the fringing profile are fixed to the window openings. Elements are fixed by screws, which "wind up" in the middle of the holes. The hardware does not twist to the end: it is necessary that the panel moves a little along its axis.
3. The installation of the lining itself is always done from the bottom up. You can easily combine different textures and colors of the siding.

At the end of the works you will get a high-quality and presentable façade: