It's difficult to say if it's easy to put linoleum on your own, if you've never done it before. But many craftsmen say that in this business the main thing is to clearly measure everything and follow the instructions. Below, we'll look at the lesson on how to properly lay the linoleum on the floor and do it as high as possible.
How to put linoleum with your own hands?
- Before putting the linoleum on the floor, we will make the basic measurements. With tape measure the largest width and length of the room. We take into account absolutely all niches, doorways and other additional projections. Then add 10 cm from each edge. This is the so-called allowance for uneven walls.
- Now cut out the desired part of the coating, according to the measurements made.
- Pay attention to this nuance: it is better to put linoleum level with the wall, if it is exactly aligned, as this will facilitate the adjustment of the remaining parts of the coating. Then near the wall opposite you will get an overlap. It is much easier to remove with a knife, than then to look for a wide plinth and overlap the gaps.
- To put the linoleum smoothly and without displacement, as practice shows, simply fixing the pieces with double-sided scotch tape. He will not let parts of the canvas "walk."
- Now the moment with the fit of the picture. Roll out a roll with a coating in the direction from the joint, and this should result in a small overlap. We combine the parts of the cover and make sure that the drawing retains its orientation and does not move.
- Now as to the moment with the undercut in the question, how to put linoleum on the floor. If we are talking about the outer corner, then we will bend over it, the incision goes to the bottom of the corner.
- If we are talking about the inner corner, we need to make an incision in the corner, which will make it possible to cover the cover tightly. Then cut off the excess.
- The pruning of the excess part in the direction of the wall is as follows.
- Next comes the difficult question of how to put linoleum on your own. Using a pencil, we literally apply the edges of the glue.
- Apply the adhesive composition from the joint.
- There is a special device - clamp. We work through a part of the coating with glue. Once the linoleum is rolled, you can cut off the remaining excess length.
- And finally, the last stage of the question, how to put linoleum, is the final docking of its parts. There is a so-called welding of linoleum. It is carried out with the help of such a needle.
- We cut off that very part of the cover that was overlapped to save the pattern. We work through the joint with a clamp.
- Now glue the painting tape on top and cut it on the seam. And then on a tube with cold welding put on a needle and wind it in the seam.
After gluing the seams, we get a ready linoleum flooring.
