Vinyl laminate consists of a layer of pressed vinyl, a decorative layer with a printed pattern, a protective coating. Such material has an exceptional wear resistance. Laying vinyl laminate can be done by hand, without much effort for a short period of time.
Technology of laying vinyl laminate
For laying you will need:
- - cementing solution;
- - Roulette;
- - stationery knife;
- - a pencil;
- - square;
- - ruler;
- - mittens;
- - plastic limiters;
- - laminate;
- - Scotch tape;
- - a hammer.
- All cracks are sealed with a cementitious mixture. The garbage is removed.
- Under the glue is rolled out an adhesive layer.
- Installation begins at the corner of the room. From the first plate, the adhesive tape is cut from the side, which will be adjacent to the wall.
- The top layer is removed from the adhesive backing.
- Fits a strip of laminate and presses well.
- Panels are brought to each other at an angle and neatly placed in the lock.
- On the perimeter of the room along the walls are placed plastic limiters.
- The film from the adhesive tape is retracted by half of the next board, the laminate is laid and from under it it gently stretches.
- Panels are taped with a hammer and rubber gasket to close the cracks. From the side of the wall a metal corner is used.
- Laminate is cut with the help of a corner, joints of an adhesive layer are fastened by an adhesive tape.
- Similarly, the material is staggered.
- If necessary, holes for pipes are cut out.
- The gaskets are removed. When observing the rules, a perfectly flat surface is obtained.
Following the instructions for laying vinyl laminate, you can independently equip a new floor in a high quality house . Such a material has all the properties of an ideal coating.
