It's hard to believe, but more recently, mobile phones have been nothing more than a simple means of communication. Today, these are real multimedia centers, concealing a thousand and one entertainment in their small building. "Communication" with a mobile phone is so addictive that many people can not make a break in it even for a short time when the phone is recharging. The result is natural - the leading positions among all the failures of mobile phones occupy various damage to the charging jacks. How to charge the phone's battery, if the charging slot has broken, you can learn from our article.
How do I charge the phone if the socket is broken?
Let's talk at once that in the case of a loose or broken charger jack, as in most other mobile problems, trouble is much easier to prevent than correct. Therefore, we advise you not to forget about the prevention: when using the phone in the recharging mode, you must ensure that the load on the socket is minimal. Otherwise, the plug of the charger will serve as a kind of lever that destroys the socket from the inside. The rule also applies when removing the phone from charging - the effort to remove the plug should be directed parallel to the plane of the phone, and not at an angle to it. If the troubles could not be avoided, then you can charge the phone with a broken socket using the following algorithm:
- Option 1 - check the efficiency of the socket in different positions . Quite often, a mobile phone with a seemingly hopelessly broken socket safely starts charging, if the charger wire is fixed in a certain position. Therefore, the first thing we advise is not to panic, but to try turning the phone with the charging connected. If the focus is successful and the phone starts charging, then fix the wire in working position by using any improvised materials: books, credit cards and, of course, electrical tape.
- Option 2 - go to the repair shop . No matter how banal this advice would not look, but the repair of the charging socket is still worth giving to the hands of professionals. The fact is that the socket in the mobile phone is not just a connector for connecting the charger, but also a rather complicated microelectronic circuit, which it is impossible to repair at home without special equipment. In this case, you should be prepared in advance that the repair of the nest will result in a round sum.
- Option 3 - charge the battery directly . Charge the battery of any mobile phone and you can bypass the socket. To do this, it is necessary to cut off the plug from the charger cord, and then to clean the insulation from the wire. After that, the wires must be directly connected to the terminals of the battery, without forgetting the observance of the polarity. This method will require some dexterity of hands and at least initial knowledge about the device of electrical devices.
- Option 4 - we purchase a universal charger. Quickly solve the problem with a broken socket and you can use a universal charger, called a "frog". To use it is simple enough - you just need to put the battery inside according to the instructions. But this method has a number of obvious drawbacks. Firstly, the cost of a "frog" can be palpably palpable. Secondly, the phone is in the off state while charging, which means it is possible to miss an important call. In addition, the Internet is not uncommon feedback that a universal charger can cause a battery death.