What to do when your reliable, proven assistant washing machine no longer collects water while washing? The reasons for this situation are not so many, and before you contact the workshop, you can also try to solve the problem yourself. Let's try to figure out where to start?
Main reasons
- To begin with it is worth checking the water supply. Make sure that there is pressure in the central system by opening any of the cranes in your house. Then make sure that the tap that supplies water to the washing machine is open.
- The machine door lock may be damaged. If the latch of the latch does not fit into the groove for a click, thereby including the relay, the water can not be poured into the unit.
- If there is a filter element in the machine, it should be checked, or it is not clogged with garbage, which in excess water is abundant.
- The washing machine does not collect water even in the event that there are malfunctions in the inlet valve. The options for its failure are quite a lot, starting with an elementary mechanical damage, ending with a burnt coil.
- The washing machine does not pump water if the pressure sensor fails. It works by increasing the pressure in the tank during the process of dialing the volume of water required for washing.
- The most unpleasant reason that water does not enter the washing machine can be a breakdown of the control module - the "heart" of this device.
If you identify the first three reasons that the washing machine does not fill the water quite easily, then it is quite difficult to sort out the latter without the special tools that are owned only by repairmen.
Methods for detecting breakdowns
If your home assistant is on warranty service, then it is better not to touch it with a screwdriver, because having unscrewed only one bolt, you can lose the warranty service of the device.
At home, you can try testing the pressure sensor, it is enough to remove the water supply hose and blow it. If its valve is defective, when the required
Having disassembled the door of the car, you can check the condition of the electronic lock. The tongue when closing should press the relay end, including the door lock. Only if the lock has worked, water will be drawn into the unit.
In the event that the cause is the failure of the control module, it is better to contact the specialists in the nearest service center. It is extremely undesirable to repair the machine in this situation, because you can do more harm than good.
Also, users may encounter a situation where the washing machine does not wring out or drain the water .