As they say, there is nothing eternal on this earth. The technique sometimes fails or just fails. Of course, it can not be denied that this is unpleasant, because the habit of technology, which helps everything, is already very strong, but, nevertheless, everything is fixable.
So, why does not the washing machine squeeze? Let's look at the possible causes of this problem to know what we are dealing with when the spin does not work.
Washing machine does not wring - reasons
- Problems with electricity . Maybe you turned off the electricity, but you did not notice? Or did you just put the cable in the wrong place, or even forgot to do it? Such ridiculous situations take place, because we are all people and, sometimes, we make mistakes or make gaffes. So, before you panic, check everything is included.
- The washing mode . The reason that the washing machine does not wring out the laundry can also be that you chose a washing mode without spinning or a delicate mode, in which the machine almost does not wring out the laundry. Again, this happens. If you can not figure out which of the modes suits you, then use the instruction that came with the machine, in which each mode is written.
- The water does not drain. There may be problems with draining the water . If water is not removed from the washing machine, it can not turn on the spin, since its sensors show too much water in the drum. For the same reason, you can not open the car door, which it will block due to water.
- Too small amount of laundry . If you loaded too little laundry into the sewing machine, it simply can not evenly spread them over the drum and because of this the spinning fails, or rather simply limits the power, since, one can say the washing machine simply "does not see" the laundry. However, the reason for this may be the initially poor quality of the equipment itself. But in general it is desirable to load the machine at least half, so that such problems do not arise, because one blouse and a pair of sock will be much easier to wash by hand.
- Troubleshooter problems. Tadachikit monitors the speed of the drum in the washing machine. And from this naturally it follows that in case of malfunctions with the device that controls the rotation of the drum, the machine can be washed, but not wrung out, and maybe not even washed. Problems with it can arise because of the old age of the machine itself or if its fastening loosened. From this problem, no machine is protected, so that all firms here are equal to each other.
- Problems with the programmer. Problems with the control module can appear for a variety of reasons - too much power surge in the network; excessive humidity in the room; getting moisture to where it should not fall, as they say; or banal marriage, that is, the original poor quality of the purchased machine.
Such a malfunction, of course, can cause the washing machine to not spin. In most cases, the module can be repaired, but there are such hard cases that it takes a full replacement of the programmer, but only the master can understand it.
So, what to do if the washing machine does not press? Of course, if the reason is not the unplugged electricity or the incorrectly selected washing mode, you should contact the service center where qualified specialists can accurately diagnose the problem or breakdown of your washing machine and professionally eliminate it. So, if you notice any problems with squeezing, then do not delay with a call to the service, as the technician can not repair itself.