To save heat is the main task in the construction of a bath . Interior decoration of the room is not enough to ensure that the building is fully consistent with its purpose. How to insulate the ceiling in the steam room? It's easy!
Analysis of the structure before the insulation
A large amount of heat seeps through a non-insulated attic floor. Most often, the inner lining consists of a board, a layer of special foil and lining, in this case lime. The ceiling is as follows:
The passage of the chimney is sewn with a sheet of stainless steel.
At the moment, from the attic side of the crate, cardboard and waterproofing are laid.
| | |
The passage of the chimney is filled with expanded clay and sewn into a metal box.
Than to warm a ceiling of a bath outside?
First of all, you need to decide on the material. We recommend filling the space with sawdust concrete. This is a profitable and economical option, since for sure after the interior finishing you have a lot of sawdust left. So, we insulate the ceiling of the bath with our own hands.
- Preparing the surface for work: fill the building foam with the space where the wiring passes.
- The heater is prepared in such a proportion: 2 buckets of sawdust goes a small bucket of cement. Add a small amount of water and mix. Remember that the solution should not flow, so as not to leak onto the wooden lining inside the room.
- Now the mixture is laid on the layer of waterproofing.
- The layer should be uniform.
- Warming can be experienced after 2 days, when everything dries.
| | |
| | |
| | |
Warming the ceiling with your own hands, try the result in practice. The recommended thickness of insulation - 150 mm, for 1 time is put a layer of about 50 mm. The result will be visible after the first stage.