How to make a floor in a private house?

The quality floor in a country house is no less important than beautiful walls and flat ceilings. After all, unlike the apartment, the chances of getting cold from the cellar into the dwelling are very high.

On how to make the floors in a private house, there are many opinions. Someone prefers wooden, and someone prefers concrete coating. Either way, it will take a lot of effort and effort to construct a floor. After all, from what you make the floor in a private house, the comfort and comfort of the whole dwelling depends.

The most practical and reliable is the warm floor , which is especially important in the arrangement of the first floor. Often, water or electric heaters are used, which are installed during the pouring of concrete roughing floors. In our master class, we will clearly show how to make a warm floor with a water heater in a private house. For this we use:

• expanded polystyrene sheets;
• plastic pipes, 1.2 cm in diameter;
• damper belt;
• polyethylene film;
• fasteners for pipes;
• reinforcing mesh with a rod of 4-5 mm, a cell of 10 x 10 cm;
• self-tapping screws;
• screwdriver;
• metal corners for pipes.
• cement-sand mortar;
• rule.

What is the right way to make a floor with a water heater in a private house?

1. On a concrete flat surface we steal a polyethylene film as a waterproofing agent.
2. On the perimeter of the room we extend the damper belt and fix it to the wall using self-tapping screws with a step of 20 cm.
3. We put a layer of expanded polystyrene on top of the film.
4. When the heat-insulating layer is ready, we lay the reinforcing mesh. In the future, it reinforces the concrete with a screed and will keep the water heater circuit.
5. Now came one of the most important stages of our master class, how to make a floor in a private house - laying a heating pipe. With the help of plastic clips, we fix the pipe to the reinforcing mesh at the rate of 3 clamps per 1 running meter of the pipe. We lay the heater across the entire floor area in the form of a snake.
6. We connect the circuit (pipe) to the collector.
7. In places where the pipe exits the screed, we install protective metal corners.
8. We make a concrete screed . To do this, we install on the surface of the lighthouse, a height of 7 mm. We fill with cement-sand mortar the floor surface between the beacons. We establish a rule on them and pull the wall away from the wall, leveling the surface of the mixture.
9. After the screed has dried, you can proceed to the decorative finish of the floor with a laminate, linoleum, parquet, parquet board or tile.