Than to warm a ceiling in a bath?

To warm the ceiling in the bath is necessary to prevent heat leakage, the better it is to be sewn by everyone chooses himself, based on preferences and financial possibilities. Competent arrangement of the ceiling will create a favorable microclimate for the adoption of bath procedures with minimal fuel consumption.

Warming can be made both from inside the room and outside from the attic side, you can combine both options or use layers of different materials.

Than to warm a ceiling in a bath from within?

There are several ways to heat the flow in a bath - use modern or traditional inexpensive methods.

Alternatively, it is possible to insulate the ceiling in a bath of mineral wool based on basalt fibers . Such material is most often used inside the room, but can also be used in the attic. To do this, ceiling beams are installed on the ceiling, between which the mineral wool plates are placed in a straight line without additional fastening. Often the material is spread in two layers.

To reflect the heat in the baths, a vapor barrier is used. The reflective layer is used with any insulation, it prevents the penetration of wet fumes into the material and the formation of condensate.

To better insulate the ceiling of the bath and provide steam, most often used Megaflex - building reflective foil with the effect of energy saving. It is used for the installation of wall and ceiling ceilings, prevents the harmful effect of moisture on the heater, keeps the steam inside the room. Due to this, a suitable microclimate is created in the therma for the treatment and stimulation of the body's immune system. The foil is attached over the insulation layer using a construction stapler, the joints are carefully glued with aluminum tape to ensure good tightness. On top of the foil, you can then mount the finish trim.

External insulation

Warming the ceiling in the bath can be clay , as this is an inexpensive and traditional method for building with an attic. On the overlap, a waterproofing layer of polyethylene or roofing material is laid first, fixed with a stapler. The clay is mixed with water and laid out in a wet state. It should not be very wet, the 10 cm layer is compacted. It is especially important to carefully seal the perimeter of the ceiling in places where it joins the walls. The use of such insulation is considered cheap and environmentally friendly.

It is easy to insulate the ceiling of the bath with sawdust . The beams are again covered by a waterproofing layer. Sawdust is usually mixed with cement, lime or clay. Water is added and a slightly moist solution is mixed. It is laid out neatly and leveled. The layer of insulation can vary from 5 to 15 centimeters. Sawdust is durable and provides excellent thermal insulation.

Similarly, you can insulate the ceiling in the bath with modern expanded clay . It is a light and porous material that does not create a heavy load on the structure. It is a round particle, which consists of burnt clay. The preparation of the overlapping surface is the same as in the case of sawdust and clay. In comparison with other heaters, it has the advantage of being non-flammable, water-resistant, rodents can not live in it. Claydite is covered with a layer of up to 15 cm between the beams of the ceiling. Many materials eventually decompose, claydite is not threatened.

Correctly chosen insulation and qualitatively executed laying will provide good thermal insulation of the premises and minimize heat loss. A modern bath is a combination of ancient traditions and newest insulating materials.