How to dilute gasoline with oil for a trimmer?

Buy a good technique for your site does not mean to get from it a maximum. When it comes to mowing a lawn , the most convenient is often the decision to buy a gas trimmer or lawnmower. However, the duration of the service of such equipment largely depends on the correct operation. Below, we will touch on the question of which oil to add to gasoline for a trimmer, and why it should be done at all.

Consequences of pouring gasoline into the trimmer without oil

What in general is the engine inside your trimmer: the piston that makes the working stroke only through the act, while the cylinder is smeared with oil mixed with gasoline. It turns out this picture: when burning gasoline, all combustion products are removed by compression, and the remaining oil does not give the force of friction damage the parts.

As a result, dilute the gasoline with oil for the trimmer is very important, since it is a pledge of a long life of technology. Otherwise, the cylinder can simply loop, as a result, the technique burns. But it is important to know what proportion of oil and gasoline for the trimmer is needed, because the excess will also lead to a decrease in power as a result of the compression drop.

What is the proportion of oil and gasoline for the trimmer?

Before you mix gasoline with oil for the trimmer, you should carefully read all the instructions from the manufacturer. We need motor oil. The ratio of the two components ranges from 1:20 to 1:50. It is important to strictly follow the recommendations specified in the technical specifications, so that no oil starvation of the engine occurs.

If you are recommended to dilute gasoline with oil for the trimmer 1:20 or 1:40, put back this oil, since too wide a range indicates a low quality of the product. If you use a similar product, power reduction is almost guaranteed.

It is possible without doubt to mix gasoline with oil for a trimmer, type M-8, since practically all trim tabs have small revolutions, and it is difficult to encounter an excess of lubricant. Due to low revs, even a relatively inexpensive oil will not cause a breakdown in technology. But what is really worth knowing is that it is not entirely legitimate refusals by service providers. The fact is that machinery manufacturers often recommend certain brands of oil for it. But even if you use oil from another manufacturer, you do not have the right to refuse warranty repairs. Unscrupulous service centers sometimes refer to this reason and refuse, although they have no legal right to do so.