Shibari is a binding technique used in the BDSM environment. It appeared in Japan and after that it spread to other territories. In this country rope has always been given special significance. During the feudal wars, the technique of capturing captives appeared, which was based on a special arrangement of the knots. They pressed on the points of the body, which made people almost paralyzed. Over time, this technology has moved to domestic life. In Japan, there were performances, in which women were especially associated.
Shibari - schemes of tying men and women
In this technique, the most important is the beauty of the lines, so it will be enough just to learn some of the nodes, and then use your imagination . A rope for shibari should be of high quality and during its tension a person must feel pain. In principle, all existing schemes must be individually tailored to the individual, his parameters and sensations .
The main elements in the schemes of shibari ties:
- Hands tied in front . The rope needs to be folded in half and tightened in a loop called "stirrup". Then it is put on the wrists, while the hands should be closed in the palms. The loop is tightened tightly, and the ends are tied with a regular knot. Such a scheme can be used for tying one hand.
- Legs bent at the knees . Now we'll figure out how you can knit your legs in the shibari technique. To begin with, you need to make a loop "stirrup" and put it on the leg of a person, which he must bend at the knee. Then a few turns around the ankle are made, and a rope under the coil is held. After that, you need to start girdling your leg in the opposite direction. End the harness is a strong knot.
- Hands behind . Everything starts again with the "stirrup" loop. In it you need to pass your left hand. After this, the rope is wound through the left shoulder, girding the chest and directing it to the right wrist. It is important to tighten the rope properly to fix your hands firmly. Then the rope goes around the right hand and reaches right up to the first turn. As a result, the rope will be near the left wrist. It must be fixed there. The process is repeated several times.
- Shibari technique for binding feet . Ankles need to be crossed and tied with a "stirrup" loop. After this, the rope is twisted several times over the shin, and it is fixed slightly below the knees. The free end of the rope must be stretched between the legs and lowered to the first knot. The next step - the rope goes between the hips in the opposite direction. After a few turns, a knot is made. During the whole process, it is necessary to tighten the rope so that the legs are tightly pressed against each other.