How to make a greenhouse with your own hands?

Today almost all summer residents or owners of country houses start to seriously think about greenhouse cultivation and acquire even ready-made structures. Some try to make a simple mini greenhouse or a greenhouse with their own hands from old window frames. If your goal is to grow a crop for the whole family and good seedlings, you can not do without a full-fledged greenhouse. Typically, for the manufacture of greenhouses with their own hands choose a material from the profile or wood, also use plastic pipes and polycarbonate. Winter greenhouses also need the organization of a heating system or good thermal insulation, which allows you to constantly keep the internal temperature at least 18 degrees Celsius.

Building a greenhouse with our own hands

The frame for building a greenhouse with our own hands will build a tube, but from the profile it is also possible. It takes a place to build the frame, screws, level and other standard tools. Together with plastic pipes we will use wooden boards.

The length of the wooden board corresponds to the desired width of the greenhouse, and from the pipe we form the same dome, on which the film will be stretched. The longer the tube and the shorter the board, the higher the greenhouse. It is important to remember that in areas with snowy winters and a very rainy season, it is not necessary to make structures with flat tops.

Operating procedure:

1. We fix one end of the pipe and begin to gradually give the roof the desired appearance.
2. From the remaining boards we begin to lay out the framework for the greenhouse. At this stage, we immediately make the workpiece and the door assembly.
3. Have made a mark under the door. A little later we will cut a piece with a hand saw. Now we will ensure the reliability of the frame for the greenhouse under the film, made by own hands. In places with fasteners we will also apply a layer of glue.
4. As soon as you give the final form to the dome, you can connect the parts of the wooden frame to each other and cut off the excess curve.
5. We fasten the tube to the frame.
6. The first section is completely finished.
7. The next step of the instruction, how correctly to make a greenhouse, consists in a covering of a skeleton. First we'll deal with the bottom part. For this we need a piece of durable material like soft plastic. This material is needed to insulate the bottom of the frame.
8. And now we begin to cover everything with film.
9. We wrap the structure, fix it and cut off the excess.
10. In this greenhouse device, manufactured by own hands, full doors are provided, and therefore they should also be isolated from moisture. Cut out the hole under the aisle, but leave a little film exactly to wrap the wooden frame.
11. The first section is set to its place.
12. For the rest of the sections, we need to install iron poles as supports. Their location should be checked by level during installation.
13. We pass to the last stage of the instruction how to make a greenhouse with our own hands. We begin to fix the sections to the iron supports.
14. Preliminary, we should also note the width of the structure along the entire length. To do this, you can pull the line between the iron supports.
15. Now you need to build a frame of plastic arcs. Along the line we attach iron pins, later we will attach plastic pipes to them.
16. Two wooden guides are needed for structural rigidity.
17. This is how the fixation of the plastic and wooden parts of the frame looks.
18. The next part of the instruction, how to make a greenhouse with your own hands, is to tighten the frame. To do this, on the ground we attach the film to the wooden guides, which will then be fixed on the lower part of the greenhouse.
19. We toss the film and likewise fix the second edge.
20. In the end, we got one of the greenhouse options for a film made by ourselves, for a perfectly acceptable, practically minimal amount.